To test this feature, visit your live site.

prob with ominirig and icom

GM I would like to report a problem between ominig and varac with my icom 7600. The transmitter switches to transmission but cannot switch back to reception, as if a command was missing to switch it back to rx. I have made numerous attempts but nothing works. what could I watch?

thank for infos .

73 Eric F1SMV

8 comments

8 Comments

irad d

Apr 25

Hello Eric

Are you using OmniRig with other softwares where it works well - or it is the first time with VarAC
Can you share a screenshot of your OmniRig screen and the VarAC RIG Settings screen ?

73s

Eric Cohen

Apr 26

Replying to

GE Arad

i dont use omnirig with an other soft. wsjtdx drive icom directly without using omniirg.

screenshot just after.

73 Eric

irad d

Apr 28

Replying to

Thank you.

It seems it is an omnirig misconfiguration for your rig. VarAC is sending a PTT OFF to omnirig. if Omnirog commands are not well aligned with your specific rig - it wont work.

Why using Omnirig if you can work directly like with WSJTX ? Simply use direct Cat control.

I can't solve an issue with OmniRig configucation for IC-7600.

73s

Irad

Eric Cohen

Apr 29

Replying to

Gm Irad

i tried too directly with cat port com and nothing..:( but i notice that problem is with wstj too these latest days ..after investigate all we and finally with wsjt i use commander from dxlab and all is ok ..at this time , hi..

(i tried too fldigi without any good result) prob seems with pc. ( i run dism /Online /Cleanup-Image /restorehealth to clean image too) ..so is it possible to add commander in todo list of driver ?

בון סמיין