The version of VarAC released on September 19, 2023, disabled rig control on my Yaesu FT-991A. I've never had problems with this until I installed the latest update. The only way to control my radio now is through FlRig. I have reverted back to a previous version until the bug is fixed.
top of page
bottom of page
Have the same problem. VarAC and FT-991A can only run with FLRig from version v7.1.7 to v8.2.0. Until version v7.1.4 no problems with Win10. Swapping the "VarAC_cat_commands.ini" does not bring success. JS8call, WSJT and several other SW work without problems. Reinstallation of drivers and SW without success. Think problem is in VarAC no other SW shows this problem. Would be nice if the problem could be fixed.
Translated with DeepL
Very very strange. Have an FT991A here. am running the latest varac rel. Used the windows installer. installs perfectly, runs perfectly. Would be tempted to suspect your installation since as said, 8.2.0 runs like a dream here. was working ZL land earlier. Perfectly. Using the onboard soundcard via USB A to PC.
JS8CAll, WJTX, HRD, Vara/Winlink express, FT8... all run perfectly. Do check out your settings and I bet you will find somehing has changed. Most likely suspects ? CAT rate ( I run 38.4) and all your soundcard settings.
Wishing you good luck,
Albert. EI7II.