Manual slot selection while connected

This is a possible bug, or maybe just a simple feature request but I would like to tell the software which slot I'm on manually, during a QSO while I'm connected to another station - this is for a radio not connected via CAT - so QSY and frequency changes are done manually.

Example: Yesterday evening I connected with a station on the calling frequency (7.105mhz), and then initiated a QSY request to Slot 4. The pop-up window appeared telling me that I needed to "Hurry and QSY manually". I changed the frequency on my radio to 7.102mhz, and clicked "OK" on the pop-up window. However, the frequency in the upper left corner did not change, and remained on 7.105. I was given the warning that I was on the calling frequency and then was automatically disconnected after the time limit was reached. I was unable to tell the software that I was actually on Slot 4 because the slot selection field is disabled while you're connected to a station.

I realize I'm probably one of the few that does not use CAT commands with their radios and this probably isn't an issue for most people 😀