Hello again Irad. I hope you don't cringe every time you see a bug report from me. I seem to be finding more than my share of glitches (grin).
The latest version ran fine last night during the brief testing I gave it (long enough to size font's, change backgrounds, and try a few CQ's and beacons).
I loaded version 2.5 today and it worked fine, until after I exited it to run another program, and then went to start it up again.
What happens now is that the only screen that opens is the VARA screen. If I look on the taskbar at the bottom of Windows, it shows both Vara and VarAC are open, but when I click on VarAC, nothing happens.
I've tried warm booting, and then cold booting into Windows, and it didn't fix the issue. I've gone back to version 2.4 and it's working fine.
73, Joe
Fixed in V2.6. will be released soon
Hi, I had the same problem and found that after I reinstalled V2.5 it worked perfectly and loaded every time. (And still does)
I think maybe V2.5 hadn’t installed properly and it was a W10 issue rather than a varAC issue. I do think that there is something a little odd with the way varAC talks to W10 but I haven identified it yet as once it’s working it’s fine.
Peter GW4OZU
@wd4kav
I looked at the Vara.ini configuration. seems like it was dragged out of screen like big time :) ScreenPositionX=-32000 ScreenPositionY=-32000 Reset to 0 for both parameters and start over V2.5
@wd4kav On the contrary Joe :) bug reporting is a critical piece in making a product good. Can you please upload the following files so I can try and simulate. all files reside in the VarAC directory.
Use the upload button down below when commenting back.
VarAC.ini
VarAC.log
VarAC_frequencies.conf
VarAC_ptt_commands.conf
Thanks.