When qsying off of the slots to use 2300hz, we have to decide on a frequency, QSY, disconnect, change to 2300 manually, then reconnect. Can a command be made to pick a freq and width, then hit GO, then VARAC takes it from there?
top of page
To test this feature, visit your live site.
7 Comments
bottom of page
I understand it not being used in the slots, what if it only allows 2300 during the qsy if the freq isnt in the slot sections? the qsy could be normally 500 as it is now, but if you manually select a freq away from the slots, another option pops up allowing 2300 upon qsy.