Hi everyone, I am using the command set attached below (as received from Irad) for CAT control of the IC-821H but I get no responce from the radio. RTS PTT is working. Any suggestions how to fix it?
CAT from FT-8 works flawlessly using the same cabling-interface, port numbers and 9600 speed.
[Icom IC-821]
CmdType=HEX
PTTOn=
PTTOff=
ModeUSB=FEFE4CE00601FD
ModeUSB_D=FEFE4CE00601FD
SetFreq_Data_method=BCD
SetFreqVfoA_Cmd=FEFE4CE005{}FD
SetFreqVfoA_param_length=10
SetFreqVfoA_hz_res=1
ReadFreqVfoA_Cmd=FEFE4CE003FD
ReadFreqVfoA_Result_Data_method=BCD
ReadFreqVfoA_Result_hz_res=1
ReadFreqVfoA_Result_Length=17
ReadFreqVfoA_Result_Freq_Start_Pos=11
ReadFreqVfoA_Result_Freq_Length=10
VarACStartCmd=
VarACExitCmd=
Enable debug mode (under settings), perform some frequency change/reads and attach the VarAC.log section so I can take a close look.