To test this feature, visit your live site.

Adding Monitor Vara HF Modem.

Hi,

I asked on FB, but no specific response. I have copied my Vara Modem folder contents to a 2nd "monitor" folder. In VARAC on settings/config page(below) VARA Monitor just shows "Port"

Which port does this refer to..?? Command or KISS when I setup the 2nd modem

Many Thanks... Dave ~ G8LIY

9 comments

Comments (9)

Dave - G8LIY

Jan 31, 2023

Hi Gary,

Configured by the .ini Now just need some signals to test it on :)

Many Thanks

NC3Z Gary

Jan 31, 2023

Replying to

Plenty of signals around, 10M has been especially good and busy for me into your neck of the woods.

Dave - G8LIY

Jan 30, 2023

Hi Gary, Did you see my question about how to config above

Thanks... Dave

NC3Z Gary

Jan 30, 2023

Replying to

yes, I thought I replied.

NC3Z Gary

Jan 30, 2023

Ultimately it should looks something like this. And dont forget when you have it all set to turn On Monitor on your monitor instance.

NC3Z Gary

Jan 30, 2023

COMMAND for Monitor. And thanks for the screenshots on the front end, it saves so much time.

Dave - G8LIY

Jan 30, 2023

Replying to

Hi Gary,

Many Thanks...

Do I need to run the 2nd modem standalone 1st to configure it. Then let it start with VARAC from then on..??

Thanks... Dave

NC3Z Gary

Jan 30, 2023

Replying to

You have a couple of ways of doing this. I prefer to just edit the VARA HF ini file. But you can always just start the 2nd (monitor) instance and set the port, then close and sate VarAC and set the path and port. Doesnt really matter or hurt anything which way you do it.

Dave - G8LIY

Jan 31, 2023

Replying to

Hi Gary,

Many thanks...

Will look at the .ini file and see if its obvious I can look at the Current Modem for Reference.

Dave ~ G8LIY