Greetings varac community. First let me say I am very impressed with this software. I am a bit surprised more people are not using it. I am having a problem with the Auto QSY Frequency Ranges button. When I clicked on it windows wanted me to select a program to open for some reason rather than just allowing me to set it. I selected VARA AC but now it just launched the entire program over again. Is there a way to fix this so that I can properly enable the Auto-QSY Frequency Ranges? I basically want to select the band skip option and then enable 20M and 10M since these are the only antennas I have. TNX
top of page
To test this feature, visit your live site.
Auto-Qsy Frequency Ranges Drop Down Settings Will Not Open
Auto-Qsy Frequency Ranges Drop Down Settings Will Not Open
5 comments
Like
Comments (5)
bottom of page
OK, so I would just edit it like below for 20 and 10 meter only operation with regards to auto-QSY?
# This file contains ranges of frequencies that you allow to auto-QSY to without your intervention.
# When a QSY invitation is received, and you are in 'allow auto-qsy' mode, VarAC will make sure
# the target QSY frequency is within the allowed range. Otherwise, the QSY invitation will be rejected
#
# These are 'Dial' frequencies. VARA will occupy an additional 1.75KHz from the dial freq.
# It is your responsibility to know what your band limits are.
#
14.101.250-14.108.750
28.101.250-28.108.750
It is a txt file. It ask you for a software to edit the txt file. Simply selece notepad.