When I go to 14.105Mhz and make a CQ my IC-7300 will transmit but without the beeps as usual with Varac.
I only have this problem with Varac. I also use other software programs such as MultiPSK, Ham Radio Deluxe, FT8 and FT4 but I don't have this problem with this software
Who can possibly help me?
73
Marcel, PE1LUP
Hoi Erik.
Zie jouw mail.
73, Marcel
Marcel,
Are you able to work the PI3EHV repeater or have DMR? I would probably be able to help you in Dutch if needed as i have the same setup. When QRV i'm always monitoring the DMR 20431 Talkgroup (Limburg) so give me a call if you would like my help. If your not able to use DMR we could try PI3EHV but we would need to schedule something as i'm normally monitoring local repeaters is my area. Check my e-mail address on my QRZ page if you want to contact me.
73
Erik
Hi Irad.
When I put the rig in USB nothing happens at all. Only USB-D
The VARA modem pushes out the audio to your rig. VarAC only keys the PTT.
I have no way of knowing why this is happening as it is out of the scope of VarAC.
One thing for you to look into:
VarAC put your RIG in USB-D mode according to your setup. And you can change it to USB and test if your setup does not work with USB-D. worth a try.
Hi Irad.
Here are the two screenshots.
Can you send the VarAC setting screenshot ?
No, according to Varac's display I work at 14.105 Mhz and that can also be seen on the display of the set IC-7300,
I must see it to believe it. your transceiver transmit on 14.104.99 but not on 14.105.00 ??
Hi Gary.
When Varac is transmitting, you can hear the beeps on the IC-7300. Just not on 14.105 Mhz.
Only on 14.105 Mhz. Other freq are all perfect.
What are beeps? An this only happens on 14.105MHz??