Hei . I am just starting with Vara. I have no decoding of any signals. On VaraHF I have a waterfall NOT inside the red lines. I used 2300 Hz > the lines are wide and the waterfall inside them, but still no decoding. I set the psk shift of the FT-991A at 1000Hz , still the same problem. Someone any idea? Thanks de DF7ET Bernhard
top of page
bottom of page
VarAC usere 500Hz not 2300. it clearly states that and when you try to swotch to 2300 it gives you a warning it says you wont be seen.
Switch to 500Hz on the VarAC console and you'l see the read lines moves closer.
Start by sitting on 14.105 for a while (USB) and you should statrt seeing beacons/cqs in a matter of a few miuntes. leave it for 1-2 hours just in case.
73s